Imagine the following scene: You are quietly watering garden plants with a brand new rubber hose when you suddenly realize that the flow of water is slowing down. When checking what is the problem, find out the hose? remember: brand new? bore a hole or let water escape somewhere. Do not despair, is it possible to fix the defect without needing another hose? or the help of a man.
If the problem is in the seal between the tap and the hose
It may be that the leak is not in the hose itself, but precisely in the encounter between it and the tap to which it is connected. If so, check that the sealing nut on the tap is loose. You can do this simply by tightening it with a wrench.
If this does not solve the problem, loosen the sealing nut completely and remove it from the tap fitting. Buy a roll of thread seal tape? do you find it in hardware stores and even some supermarkets? and wrap a generous piece of tape around the tap thread. Refit the hose nut and tighten it with the wrench.
If the problem is sealing between the hose and the sealing nut
It is also possible that the hose seal nut itself is not fulfilling its role properly. To eliminate the problem, look for a hardware or building supply store and buy a new hose clip. When you get home, cut off the end of the hose to which the old nut was attached and attach the new nut to the end.
If you don't know how to do the job, a good tip is to ask at the tool house. Usually sellers know how to advise on the use of products sold there. This saves time and mental strain.
If the problem is in the hose nozzle
Some people prefer to attach a type of nozzle to the "tip" of the hose. the amount of water expelled by it. These nozzles often give you a headache because they may start to not close properly over time. If, even when in the "closed" position, the nozzle is still leaking, it may be time to replace it.
For nozzles that are simply threaded into the hose end, this replacement is simple and can only be done by pulling out the old nozzle and fitting the new one. In cases where the nozzle is fastened by clamps or buckles, you may need to cut off the end to which it is attached in order to fit the new one.
If the problem is a hole in the hose
Depending on the location of the hole and its length, a patch can be made with an epoxy resin. It is a type of plastic that comes with a "hardener" material. After applying the resin around the hole, with the hose dry, apply this material on top and let it dry. In cases where this solution does not resolve, some patch kits can be found at garden houses or building supply stores.
How to DIY Repair a Damaged Garden Hose (4 Easy Ways) | GOT2LEARN (March 2024)
- Organization
- 1,230
